Zdravo,
Mogoče komu prov pride...
Na seat Alhambri se mi je prižgalo obvestilo: AdBlue no engine start in 1000 km. ikona za doliti adblue in spodaj ključek
Priklop in prgled z VCSD mi je pokazal napako :
Tuesday,27,December,2016,16:48:39:62939
VCDS -- Windows Based VAG/VAS Emulator
VCDS Version: 12.12.0.0
Data version: 20130910
VIN: *********** License Plate: 11111111
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Address 01: Engine Labels: 03L-906-018-CFF.clb
Control Module Part Number: 03L 906 018 HL HW: 03L 906 018 M
Component and/or Version: R4 2,0L EDC H27 9228
Software Coding: 0019001A042401080000
Work Shop Code: WSC 00020 999 00000
ASAM Dataset: EV_ECM20TDI01103L906018HL 003006 (VW36)
VCID: 7BF51167F210BBC6C11-802E
1 Fault Found:
15733 - SCR NOx Catalyst Bank 1
P20EE 00 [101] - Efficiency too Low
Not Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 1
Mileage: 98153 km
Date: 2050.14.02
Time: 12:56:58
Readiness: 0 0 0 0 0
Po izbrisu napak z VCSD mi je opozorilo še svetilo, vendar ponovni scan ni pokazal napak...
Probal veliko stvari:
- Resetting of SCR Tank Level Detection
- Reset SCR Lock
- Diesel Particle Filter Emergency Regeneration ->
http://wiki.ross-tech.com/wiki/index.ph ... generation- Po pogovoru z mehanikom tudi pri kontaktu - izklop akumulatorja. čakanje 10 min.
vendar na koncu se je izkazal uspešen postopek ki sem ga našel preko interneta:
http://forums.ross-tech.com/showthread. ... -ProcedurePrerequisites:
- Engine fully warmed up (above 80’C) and idling
- Transmission in Park/Neutral
- Emergency brake = On
- Doors and hood are closed
- Do not depress any pedals during this procedure, until instructed to do so.
To Reset the AdBlue Level:
- Clear all fault codes(yes, even if there are none present)
- Select 01-Engine]
- Select [Basic Settings-04]
- From the pull down menu choose:
- - - [Resetting of learned values of average quantity adaptation], press [Go!]
- - - - After completion, Press [Stop]
- - - Then [Reset learned values quant. meter. unit and press. contr. Valve], press [Go!]
- - - - After completion, Press [Stop]
- Select [Check of SCR efficiency], press [Go!]
- Depress Brake pedal, then depress accelerator pedal, the ECM should take control of the Engine speed.
- This test may take up to 30+ minutes to complete!
- Upon completion, you should see ‘System Okay’, the AdBlue light and the warning message about ‘miles to no start’ will be reset. Verify there are no fault codes.
Sedaj dajmo času čas. Če je karkoli narobe z senzorjem Nox -a ali na tem sistemu bo verjetno ponovno zajambral...