Lep pozdrav, opravicujem se ce sprasujem ze vprasano, vendar tocnega odgovora na to vprasanje (se) nisem nasel na forumu.

Torej: zanima me koliko lahko ET platisca odstopa od tistega ki je dolocen v homologaciji. Na www.carbibles.com sem prebral tole:This figure will be stamped on the wheel somewhere as an ET figure. Inset and outset are subsets of offset and the relationship is this : positive offset = inset. Negative offset = outset. Typically you can get away with 5mm-7mm difference from the vehicle manufacturer specification before you'll run into trouble with the wheels fouling the suspension or bodywork. So for example if your stock wheels have an offset of 42mm and you can only find replacements with a 40mm offset, that 2mm difference ought to OK.

Kupujem namrec nova platisca ki po vseh dimenzijah ustrezajo tovarniski homologaciji, razen ET ( doloceno je 42, imajo pa 38 ). Zanima me ce ima kdo kaj izkusenj z taksnimi zgoraj omenjenimi "poskodbami" zaradi napacnega ET?

Pa se to: ali moram dati homologirati platisca tudi ce so original znamke mojega avtomobila?

hvala za odgovore!